Anchor-Tite Product Knowledge Video from Super Glue Corporation.
The Epoxy Dynamic-MixerTM is designed to energetically and forcefully mix 2 part epoxies into a single strong adhesive.
Place the ACTIVATOR and the RESIN in equal parts into the Dynamic-MixerTM.
Using your fingers, mix the product vigorously until it is combined to form the adhesive.
Snip the tip of the Dynamic-MixerTM and dispense the adhesive onto the desired surface. In the timeframe designated, place the 2 substrates to be joined and wait for the product to cure (harden). Epoxies are generally designed to be fully cured (hardened) in 24 hours. There is nothing Static about the Dynamic-MixerTM. It Works!
Pacer Technology cyanoacrylates certified for compliance to MIL-A-46050C and to commercial item A-A-3097. Certification status is verified by this interchange. Shipments can be certified by batch number and by purchase order.
NOTE A*: For Section 3.2.1. Compliance, the ISL products will be supplied colorless. Request for dyed products should qualify this deviation from the specification.
NOTE B*: These products are Isopropyl-2 Cyanoacrylates - No type category exists for this chemistry on the current MIL-SPEC. Request deviation from spec as required for each application.
*Pacer Technology products may exceed the maximum prevailing strength values on plated parts as shown on Table III or section 3.4.1 of MIL-S-46163A. Performance specification ASTM D-5363 is intended to replace this specification.
SIMPLIFIED PRODUCT IDENTIFICATION
Pacer has simplified the instant adhesive selection process by defining the chemical type (letter) with viscosity number designations (i.e. E-5 means ethyl chemical type at a viscosity 5 cps RX-100 means Range Extended at 100 (cps.). All Pacer instant adhesive labels are color coded according to cure time.